
Heat is the main enemy of aroma. The compounds that make a lemon peel smell like lemon, or a cannabis flower smell like pine or citrus, are volatile, which means they leave easily and react easily. How you pull them out of a plant decides how much of the original smell survives. This post uses published measurements to show what changes, and what to ask a supplier about it.
Why these molecules are fragile
Most of the aroma in cannabis and citrus comes from terpenes. The common ones are small molecules that boil at fairly low temperatures. These values come from the reference entries in PubChem.
| Terpene | Type | Boiling point at 760 mm Hg |
|---|---|---|
| Alpha-pinene | Monoterpene (C10H16) | 156 °C |
| Myrcene | Monoterpene (C10H16) | 166 to 167 °C |
| Limonene | Monoterpene (C10H16) | about 178 °C |
| Terpinolene | Monoterpene (C10H16) | 183 to 185 °C |
| Caryophyllene | Sesquiterpene (C15H24) | 256 to 259 °C |
Sources: PubChem entries for alpha-pinene, myrcene, limonene, terpinolene and caryophyllene.
Two points follow. The lighter monoterpenes sit well below 200 °C, so any step that heats a plant or an extract for long can drive them off. And the heavier sesquiterpene boils roughly 70 to 100 degrees higher, so the mix of aroma notes changes depending on how much heat a process applies.
Boiling is only one way to lose aroma. A 2024 study of citrus oils notes that volatile compounds "can be easily degraded or oxygenated" by headspace oxygen, enzymes and heat. It adds that heat can decompose the active aroma compounds or form off-flavor compounds.
The main extraction routes
The same study lists the standard ways to get essential oil out of citrus: distillation (hydrodistillation, steam distillation and dry distillation) and nonthermal methods (cold pressing, supercritical CO2 and solvent extraction). The split matters. Distillation uses heat. The nonthermal routes avoid it, at least in the extraction step.
Two published comparisons show what that difference does in practice.
Case 1: cold pressing vs hydrodistillation in citrus
Citrus oil sits mostly in the peel. The study says citrus oil accumulates in secretory cavities in the flavedo layer of the fruit.
In that 2024 study, Park and colleagues prepared oil from orange and tangor peels two ways: cold pressing and hydrodistillation. They found the two methods gave different volatile profiles:
- Cold pressing produced oil with more sesquiterpenes, oxygenated monoterpenes and fatty acid derivatives.
- Hydrodistillation produced oil with more terpinyl cation derivatives, limonene and 4-vinylguaiacol.
- During hydrodistillation, terpinen-4-ol and 4-vinylguaiacol, which the authors describe as off-flavor compounds in citrus juice, formed more abundantly in the orange than in the tangor.
The paper also notes that off-flavor compounds such as alpha-terpineol and d-carvone can form through acid-catalyzed degradation of limonene.
The practical read: two oils from the same fruit are not the same oil. The method leaves a fingerprint.
Case 2: supercritical CO2 and pressure
Carbon dioxide becomes supercritical above about 31 °C and 74 bar (PubChem lists a critical temperature of 304.13 K and a critical pressure of 7.375 MPa). The authors of a 2022 hemp study describe CO2 near its critical point or in the supercritical range as "a very efficient solvent for certain types of compounds".
What makes it useful is that you can tune it. In that 2022 study, Jokić and colleagues extracted industrial hemp flowers with supercritical CO2 at different pressures and temperatures. They found:
- A low pressure of 131.2 bar was best for monoterpenes.
- Extracts rich in sesquiterpenes came at 319.7 bar.
- A high pressure of 284.78 bar was best for CBD.
- Across the responses studied, 60 °C was optimal.
Two things stand out. Pressure, not just temperature, decides which part of the aroma you collect. And "cold" is not the whole story. The best conditions in that study were at 60 °C, which is well below the boiling points above but not cool. The right settings depend on what you want out of the plant. The study used one hemp sample, so treat the numbers as an illustration, not a recipe.
What this means when you choose a supplier
None of this says one method is best. It says method and aroma are linked, and that a supplier should be able to talk about the link. Questions worth asking:
- What is the starting material, and was it fresh, dried or frozen?
- What does the supplier measure on the finished terpene, and can you see the batch report? Our COA guide covers that.
- Does a repeat order match the first? See why flavor drifts between batches.
If you are working with concentrates, our posts on flower vs concentrates and terpenes for distillate go into format-specific points. For the chemistry vocabulary, see aromatic compounds in cannabis.
Where Entour™ fits
We are not describing a production method here, because the specifics are not published on this site. What we can say is what the site says. The Werc Shop® was the first commercial cannabis laboratory to offer terpene testing, in 2011, and the site describes its terpene analysis methods as including high-resolution fingerprinting of individual cannabis cultivars. The True To Plant® process recreates cultivar-specific terpene profiles "through the use of natural, non cannabis ingredients".
The point of fingerprinting is the one this post keeps coming back to: if you can measure a profile, you can aim at it, and check afterward that you hit it. Our guide on True To Plant vs generic strain profiles explains what that changes for a brand.
FAQ
What is the best extraction method for aroma?
There isn't one. The citrus study shows cold pressing and hydrodistillation give different profiles from the same fruit, and the CO2 study shows settings change what you collect. Match the method to the material and the result you want.
Does heat damage terpenes?
It can. A 2024 citrus study notes that heat can decompose aroma compounds or form off-flavor compounds, and that oxygen and enzymes also degrade them. The effect depends on the compound and the process.
Is supercritical CO2 extraction always low temperature?
No. In the 2022 hemp study, 60 °C proved optimal for all the responses measured. It is low compared with boiling points, but it is a setting, not a fixed property of the method.
Why do monoterpenes and sesquiterpenes behave differently?
They differ in size, 10 carbons versus 15, and in boiling point. Alpha-pinene boils at 156 °C and caryophyllene at about 256 °C, so heat affects them differently.
Where to take this next
If you want a profile built around a specific cultivar, talk to the team about custom terpene blends.
About the author: The Entour™ team is a division of The Werc Shop®, the first commercial cannabis laboratory to test for terpenes back in 2011. The team formulates True To Plant® terpene profiles for licensed cannabis brands across the US, Canada, and tribal markets.
Read More

Limonene: Everything You Need to Know
Citrus’ many beneficial properties is why so many products, from beverages to household cleaners, use a pleasant citrus aroma as an additive. It’s also widely used as a flavor or scent agent in products such as beverages, candies, chewing gum, and baked goods, as well as in aromatherapy, cosmetics, and anywhere else where a refreshing and uplifting effect is needed, including, you guessed it, cannabis! And it’s all thanks to a fascinating and versatile terpene called limonene.

Are Terpenes Safe? 7 Common Terpene Myths
Cannabis producers understand that the key to fostering organic business growth is through offering high-quality products their customers will love, and keep coming back for. Much of their business success relies on using high-quality terpenes

What Are Terpenes? Effects, Types & Uses Explained
You've probably heard about terpenes, but do you truly understand their impact and ubiquity? Terpenes are organic compounds, pivotal in the natural essence of plants. They are the unsung heroes behind the captivating aromas of flowers and the distinct flavors of fruits. Their roles extend beyond mere sensory delights; they play a crucial part in plant survival and attraction.





